Anatomy of bubbles in epoxy floors

In interior design¬†industry, Epoxy is a widely used chemical material that used as a coating to variety kind of floors. People like epoxy because epoxy floors are very durable, highly resistant and fabulously presenting. As artificial resin, epoxy’s inexpensive price simply expand its fan base to an enormous amount. However, such a popular coated floor has its own flaws and sometimes it just make one feel helpless.

After installing epoxy coating, some people may happen to find out that some bubbles are appearing on their floors. These bubbles will grow to a certain size from a diameter of 20mm to more than 100mm. Some may occur right after installation while others may occur after a whole while. Some people might think the bubbling is due to the different medium that the epoxy attached to. However, the occurrence of the bubbles are simple as that.

Through numerous time of practices, People discovered that even the same group of workers using same material on the same region might end up differently. If one happen to cut open the bubble, they might find some yellow color water stored in a form of honeycomb, which is truly interesting.

Theory of bubbling

According to physics, when water contained in a sealed container got heated, it will start evaporation and give pressure to the container from inside. When the pressure reach a certain level, the container may transform. In this epoxy floor case, the ground is continuously heat under sun radiation. Sometimes the temperature can even reach a extreme high of 70. C when the stickiness of epoxy coating is reduced and starting to transform.

To make it easier to understand, just imagine blowing air into the space between a piece of wind shield and its film. Whenever one do that, a bubble will comes out. The same theory apply to the epoxy floors. When the water is heated, it evaporated and become stream that similar to the air we blow.

How to prevent bubbling from happening

As you may found that the bubbles are there because of water. If we are able to make sure our concrete is dry enough before we coat epoxy, there would be much less bubbles. However when we do the coating ourselves, we couldn’t simply ask too much from ourselves as we are not professionals. Therefore we are introducing a easy-to-follow 3 steps to help you evaluate the moisture level of your concrete. Simply follow this:

  1. Tap a plastic bag onto your concrete.
  2. Wait for 24 hours.
  3. Lift the bag and check the moisture level of the side that has been touch the concrete. If it is dry, then you are ok to proceed to next level.

This is very easy, right? I believe you are completely able to do this alone. Next time, just remember to run a small check like above before installing epoxy floor to your lovely concrete. Hire epoxy floors Brisbane for a reliable  installation and service.